Optimum milling for H-13 die steel的封面
书籍主题:

Optimum milling for H-13 die steel

LAP LAMBERT Academic Publishing (2017-03-02 )

Books loader

Omni badge 有获得代金券的资格
ISBN-13:

978-3-330-05319-9

ISBN-10:
3330053194
EAN:
9783330053199
书籍语言:
英文
作品简介:
Hot Die Steel H-13 has the properties of high hot strength, hardness, good resistance to heat, good hot toughness, high resistance to temperature fatigue and wear in medium heat. The input parameters that affect the Material Removal Rate (MRR) and Surface Roughness during milling operation were cutting speed, feed, rate, depth of cut. The present work was aimed to optimize the value of input parameters so as to improve the MRR and Surface Roughness for H-13 die steel. To achieve the same, Minitab 15 software for the Taguchi design of experiment (L-9 orthogonal array) with signal to noise ratio and ANOVA approach was used. It was concluded that during end milling operation, use of high cutting speed (3000 rpm.), feed rate (0.15 mm/tooth) and depth of cut (0.2 mm) were optimized parameters to obtained better surface finish for the specific test range in a H13 material. Also, the feed rate and cutting speed were found to be the most dominant factor than the depth of cut for surface finish.
出版社 :
LAP LAMBERT Academic Publishing
网址:
https://www.lap-publishing.com/
由(作者):
Tarun Goyal
页码 :
56
发表日期:
2017-03-02
现货:
备有现货
类别:
机械工程学,制造技术
价格:
35.90 €
关键词:
milling, optimum, surface roughness, die steel

Books loader

时事通讯

Adyen::amex Adyen::mc Adyen::visa Adyen::cup Adyen::unionpay Paypal CryptoWallet 银行转帐

LOGIN
  0产品在购物车内
编辑购物车
Loading frontend
LOADING